Supporting pipes using clips or cleats is more common for towers or columns. However, sometimes the cleat support is taken from the following equipment to support pipes. Step one: Make sure walls are in a good condition and suitable for internal linings – take care to remove any vinyl wallpaper or gloss pain to leave the wall surface clean, dust-free and free from loose material(s). Ensure the wall is also dry, having any remedial work done prior to installation of the boards to remove dampness. How to install Celotex insulation for single timber frame wall lining and dormer cheeks What you need The purpose of insulating a building is to maximise its thermal benefit. The majority of insulation-fastening plugs are of plastic or nylon composition and are poor conductors of heat.

Step two: Create the vapour control layer by tightly aligning, taping and jointing the joints between the boards with suitable tape.It is essential when installing celotex rigid insulation boards in cut to fit roof applications to ensure they are secured firmly. Insulation boards falling down on your head is no fun and also you really don’t want the weight of the boards resting on your plasterboard finish. Celotex insulation clips are and ideal purpose made fixing that ensures the PIR insulation boards are kept firmly in their place. The advantage of these clips is that if you have uneven timbers or if you are unable to cut the insulation to fit tightly in between the timbers. Then these fixings will work perfectly holding the insulation in position.

Step eight: Apply appropriate sealant around the perimeter of the insulation – this will provide a vapour seal. Masonry partial-fill cavity walls are a popular type of external wall construction. In fact, they have been used for over a century. So here is what you will need to do when it comes to installing Celotex insulation boards in masonry partial fill cavity walls.Tip: For high thermal performance, place the unprinted foil face surface towards the air cavity. What you need: Due to increased care being taken regarding insulation standards, today it’s important to ensure the target U-value set for properties is met with proper insulation. The advantage of using plastic insulation fixings is that they help retain the insulation values of a building by mitigating potential heat loss at fastening positions. The disadvantage of using plastics and nylons is that they are combustible and are incompatible with an insulating system where fire-resistance is a constraint. Best Insulation Fasteners for Fire Performance The most efficient way to cut Celotex is with a hand saw. Not only does this support minimal dust creation, but in many cases, you can use off-cuts to fill any gaps that may still be there during installation.