Apart from that, clear instructions, dead simple to put up, not a bit missing from either box (two bits left over but that's fine by me). A.T free offer period,if the Forum allows it do any contributors object to me Printing this Thread to pass on to Machine Mart and ask their opinion before i spend my Pension on one,And Oblige. Contact machine mart and the makers, kick up a fuss and get them to advise and cure the problem or refund your money. As such, the front and rear panels move about quite a lot and could marr the paintwork if parked too close.

I suppose if I really wanted to I could put short self drilling screws in to secure them but then I will be taking it down each summer so I am better keeping it as is which is actually VERY sturdy when bolted down and straps tensioned. It shouldn't now as each leg is bolted down but I worry the push botton connections in parts of the tubular frame could detach in severe wind. Seller was initially reluctant to make a small partial refund which is was all I was after and even after agreeing it was slow in sending money back.

Most purchases from business sellers are protected by the Consumer Contract Regulations 2013 which give you the right to cancel the purchase within 14 days after the day you receive the item. A few straps lashed over them would make that impossible to come undone and give even more anchorage to the ground.

Condensation has been a problem in general for the last few weeks due to the unusually cold followed by unusually clement weather - worth getting some airflow through the garage tent and seeing if that dries it up. Our conservatory roof has ali beams, and despite these being covered outside and inside the inner plastic covers still drip water if there is the least hint of moisture in the conservatory on a chilly night.I am also thinking of putting large ground brackets at 2 or 3 portals and lash a ratchet strap around the frame inside.

I built a single course of bricks around the inside, which has diverted most of the rainwater but the condensation is still significant. It was put up on a concrete slab that was made for the garage extension and I bolted it down using concrete anchors.My garage door has a fibreglass skin and the inside of this used to run with water in the winter, mainly because the warm air in the garage held moisture from the warm house around it. Heavy Duty 1 1/2" Diameter Powder Coated Steel Main Frame Tubing - A highly durable powder coat is baked on to the tube frames to protect against peeling, rusting, chipping and corrosion. Now no drips partly because the breathers only see low humidity cold air from near the floor and outside, and mainly because the new inner surface is is not cold. It was cut quite clearly with a knife, plus the stupid pricks had been whinging about it being there, and me working on the Landy for weeks.

Heavy Duty Powder Coated Steel Tubing - A highly durable powder coat is baked on to the tube frames to protect against peeling, rusting, chipping and corrosion.All I’ve had to do is make a good seal to the rear door which accesses the house, it used to really blow through the gap in the frame/door.